Hi, I am going to try budgie de. Everything is fine but I need these two things. Is there any way to display them in realtime? If I got these two then I am all set to switch. Great work guyz I loved it while running it live 😃

There is a budgie-cputemp-applet that you could add to your panel. Not sure about network bandwidth.

Alternatively conky can provide all of that.

    both in a GUI? no clue. conky is my guess too for a desktop prescence.

    but realtime as in CLI there isbandwidthin the repo...
    I usehtop for cpu usage...

    but bandwidth and cpu both at the same time on a single CLI app? no clue. for as many hardware monitors/system packages there are (solus repo/flat/git) someone has had to invent these two in a single reading...

    also, budgie's own System Monitor shows close to what you need:

      brent note to self: I made a 4GB swap when I reinstalled 4.4.....says 12GB? must investigate...

          brent You have zram enabled. Swap is reported as any physical swap you have installed + zram swap.

              ReillyBrogan I believed I did that on rec of you or the team when 4.4 came out (you recc'd it for everybody I believe and furnished the terminal command). It was a beneficial thing as I recall.

              edit: found it.

              ok I remember I was trying to bring my 4.3 (I did not install 4.4) into identical footprint (for lack of a better word) as 4.4.
              can dig it.

                btop displays CPU core temps and network throughput if that's any use. nice CLI program

                There is an application called Stacer which could correspond to what you are looking for.
                But on the Github link below:
                https://github.com/oguzhaninan/Stacer
                it is specified that this project has been abandoned and so, there will be no further releases.