About Tilix

FAb7D

Tillix with some commands (on Budgie) repeats the output many times, like example:
~ $ nmcli device wifi rescan && nmcli device wifi list

IN-USE  BSSID              SSID                          MODE   CHAN  RATE     >
        .......  FASTWEB-JQ...._EXT          Infra  1     130 Mbit/>
        ....  FASTWEB-JQ.....             Infra  1     130 Mbit/>
        ...  WOW FI - FASTWEB              Infra  1     130 Mbit/>
        ......
lines 1-21/21 (END)...skipping...


IN-USE  BSSID              SSID                          MODE   CHAN  RATE     >
        .......  FASTWEB-JQ...._EXT          Infra  1     130 Mbit/>
        ....  FASTWEB-JQ.....             Infra  1     130 Mbit/>
        ...  WOW FI - FASTWEB              Infra  1     130 Mbit/>
        ......
lines 1-21/21 (END)...skipping...
..............................

Can it be corrected?

silke

I also use Tilix (on Budgie) and have not encountered this issue. The given commands also work fine for me 😕. Does this also happen in a root shell (sudo su)?

FAb7D

silke
Interesting 🤔 ... no! With sudo su work well.

silke

In that case it is probably caused by something in your shell configuration. No idea where to start finding the issue though.

If you are up for a different adventure (and using bash) you could switch to a different shell like zsh or fish. See the help center.

FAb7D

silke
Ok, thanks! (I can already say that fish works and does not repeat the output)