Update Dec 03rd 2022?

Cloak

Again, systemd interventions required.

ReillyBrogan

Cloak Oh? I'm not familiar with the issue you're talking about.

Cloak

ReillyBrogan I run a media server on the Solus machine and most updates I need to re activate targets and services.

ReillyBrogan

Cloak Do you have a link somewhere to troubleshooting steps and diagnostics you've done?

Cloak

I use this sometimes https://systemd.network/index.html to make sure I have the correct syntax in fstab etc.

ReillyBrogan

Cloak No, what I mean is that you shouldn't have to reactivate targets and services on updates and I'm curious what steps you've taken to troubleshoot the issue or if you've reported it anywhere (where I can take a look at what you've done).

Cloak

ReillyBrogan Ok, I reboot after this and previous syncs and see none of my smb fstab mounts have happened so mount manually and all is good. sudo systemctl enable remote-fs.target then reboot and all is good again with the mounts. look at the media server and see it's not running so 'enable' that as well and reboot again... All works as expected. So I've seen this on other distros before, seemed to occur a while ago after a systemd update but to be clear I find the docs on systemd to be shambolic and so expect weird things from the project.. No biggie actually...

putzerstammer

Thanks to the team Updates as always with me without errors

joluveba

Same here. I updated my two computers, they seem to work ok.

putzerstammer

Staudey even if there are no updates on Fridays we will all survive,just don't stress take the time you need when done then done 😄

david

Minor note:

I updated today. When trying to start AutoKey, it would show an error and not load:

Error starting interface. Keyboard monitoring will be disabled.
Check your system/configuration.

No module named '_tkinter'

Installing python3-tkinter solved the issue.

Don't know how this stuff works; just would have thought it should have installed itself based on a dependency.

I'm very thankful for this distro, and all the work put into it.

ReillyBrogan

david Already fixed in unstable.

david

ReillyBrogan Right on. Thanks!

Noviterm

Hi, the update was fine.

Cloak

Update fine here too. As usual a reboot after it I lost all my targets and services. This time I didn't go ahead and reset them I just performed a second reboot and .. there it was, all good... Must be something weird in this NUC bios + efi.. No sweat.

« Previous Page